Hop Router
GSR12008#configuration terminal GSR12008(config)#mpls traffic-eng tunnels
interface XXX mpls traffic-eng tunnels ip rsvp bandwidth XX XX ( reserve more, otherwise some tunnel may not up as not enough bandwidth)
router isismetric-style wide
mpls traffic-eng router-id Loopback0 mpls traffic-eng level-1
Source Router
mpls traffic-eng tunnels
router isismetric-style wide
mpls traffic-eng router-id Loopback0 mpls traffic-eng level-1
int XXXX
mpls traffic-eng tunnels ip rsvp bandwidth XX XX
interface Tunnel158 ip unnumbered Loopback0 tunnel destination 10.10.10.4 tunnel mode mpls traffic-eng tunnel mpls traffic-eng autoroute announce tunnel mpls traffic-eng priority 2 2 tunnel mpls traffic-eng bandwidth 158 tunnel mpls traffic-eng path-option 1 explicit name low ! interface Tunnel159 ip unnumbered Loopback0 tunnel destination 10.10.10.4 tunnel mode mpls traffic-eng tunnel mpls traffic-eng autoroute announce tunnel mpls traffic-eng priority 4 4 tunnel mpls traffic-eng bandwidth 159 tunnel mpls traffic-eng path-option 1 explicit name straight !
ip explicit-path name low enable next-address 10.1.1.21 next-address 10.1.1.10 next-address 10.1.1.1 next-address 10.1.1.14 ! ip explicit-path name straight enable next-address 10.1.1.21 next-address 10.1.1.5 next-address 10.1.1.14
ip route xxxxx xxxxx tunnel 1 ( direct the traffic using Tunnel 1)
Verify
show Commands
This section provides information you can use to confirm your configuration is working properly.
The Output Interpreter Tool (registered customers only) (OIT) supports certain show commands. Use the OIT to view an analysis ofshow command output.
- show mpls traffic-eng tunnels brief
- show mpls traffic-eng tunnels name Pesaro_t158
- show ip rsvp interface
- show mpls traffic-eng topology path destination 10.10.10.6 bandwidth 75
Other useful commands (not illustrated here) include:
- show isis mpls traffic-eng advertisements
- show tag-switching forwarding-table
- show ip cef
- show mpls traffic-eng tunnels summary
沒有留言:
張貼留言